User Manual


ReceiverAuto‐Detection
AuniquefeatureoftheVortexfamilyofquadcoptersisthatthereceivertypeisauto-detectedby
theOSDwhenrunningthewizard.
WiththeVortex250Pro,itisnolongernecessarytomanuallyspecifythereceivertypewiththe
ImmersionRCToolsbeforerunningthewizard.

R/CTransmitterConfiguration
DependingupontheR/Ctransmitterinuse,certainparametersneedtobemodifiedinorderto
ensurecompatibilitywiththeVortex250Pro,andmoreimportantlywiththeCleanflightFlight
Controllerfirmware.
Inallcases,duringthewizardsetup,thecurrent‘PPMValue’isshownon-screenbesideeach
control.Thisvaluemustbeascloseaspossibletoamin.of1000,centerof1500,andmax.of
2000.
Itishighlyrecommendedtostartwitha‘clean’configuration(newmodel)forallradios.
Spektrum™Radios
Spektrumradiosneedthefollowingconfiguration:
- Twochannelsneedreversing,AIL,andRUD.
- Mapchannel5toa2or3-positionswitchtocontrolflightmode(Acro/Horizor
Acro/Level/Horiz).
- Verifythattheendpointsare1000/1500/2000asdescribedabove.
FrSkyTaranisRadio
- Mapchannel5toa3-positionswitchtocontrolflightmode(Acro/Level/Horiz).
- Verifythattheendpointsare1000/1500/2000asdescribedabove.
FutabaS‐BusRadios
- Mapchannel5toa3-positionswitchtocontrolflightmode(Acro/Level/Horiz).
- ReversechannelsELEandTHR
- Changesubtrimto-31forTHR,AIL,ELE,RUD
- Changetravelto+/-119onallchannels.
- Verifythattheendpointsare1000/1500/2000asdescribedabove.





6

