User Manual



2)Alsoremovethetwoscrewsatthebottomoftheright-handside-plate,andremovethe

side-plate.

3)RemovetheinstalledCPPMcable.

4)Lookingintherightsideofthequad,awhiteconnectorisvisibleonthefusion(flight

controller)board.

InstalltheincludedS-Bus,orSpektrumcable,asrequired.Notethatthefactthatthetopplate

screwsareremovedontherearofthequadmeansthatthetopplatecanbeeasedupafew

millimeterstoallowtheconnectortobeinstalled.Don’tforcethetwoaparttoomuch,orrisk

damagingthePDB.



NotesonReceiverSelection

Onecriticalparametertokeeptoaminimuminaracequadsetupislatency.Latencyfromwhat

thecameraseestothedisplaydevice,andalsofromthecontrolsticktotheflightcontroller.

Forminimumlatency,withreasonablerange,theSpektrum™radiosandsatellitereceiversarea

greatchoice.Anothergood(andquitecommon)choiceistheFrSkyTaranisradiowitha

matchedS-Busreceiver(X4Rforexample).

Forlonger-rangeFPV,theEzUHFsystemisagoodchoice.Duetothecloseproximityofthe

electronicsandVideoTransmitteronamini-quad,andthelackofasuitableground-plane,a

diversityreceiver,withdipoleantennasishighlyrecommended.



Note:AnupdatetoallexistingEzUHFsystemswillbeavailableearlyDec.2015,whichwillenable

anS-Busoutput,asopposedtothemoretraditionalPPM.Thiswillgreatlyreducelatency.



 



5

