User Manual


1)InstallCompatibleR/CReceiver
TheVortex250Proisshippedwiththreereceiverinterfacecables,oneforCPPM,oneforS-Bus,
andonefortheSpektrumreceivers.
Cleanflightprovidesalistofreceiversstatedasworking,sopleasecheckifyoursislisted
here:https://github.com/cleanflight/cleanflight/blob/master/docs/Rx.md

CPPM
Asitships,theCPPMcableispre-installedinthequad.IfaCPPMreceiveristobeused(such
astheEzUHF,orotherCPPMreceiverson2.4GHz)thereceivercansimplybeattachedtothe
rearmountingplate,andthecableconnected.Noothercablingisrequired.
CPPMsendsallPPMchannelsdownasinglecable,andeliminatesthemassofwiringthat
mostmini-quadshavetocontendwith.
NotethattheVortex250ProisnotcompatiblewithstandardR/Creceiverswithmultiple
channelsofPWM,eachconnectedviaaseparatecable. 
Thereceivershouldbemountedontherearofthequad,ontheshelfprovided.Avelcrostrap,or
apieceofdouble-sidedtapeisthebestwaytomounttheareceiver.
SBus,orSpektrum
Tosupportoneofthesereceivers,acablemustbeinstalledinthequad,whichdoesrequire
removingafewscrewstoaccesstheconnector.
1) Removethescrewspointedtobelow:




4

