Theory XL Manual

7
EN
Band
CH 1 CH 2 CH 3 CH 4 CH 5 CH 6 CH 7 CH 8
FS/IRC 5740 5760 5780 5800 5820 5840 5860 5880
Band E 5705 5685 5665 5665 5885 5905 5905 5905
Band A 5865 5845 5825 5805 5785 5765 5745 5725
RaceBand 5658 5695 5732 5769 5806 5843 5880 5917
Band B 5733 5752 5771 5790 5809 5828 5847 5866
Band CH 1 CH 2 CH 3 CH 4 CH 5 CH 6 CH 7 CH 8
FS/IRC 5740 5760 5780 5800 5820 5840 5860 5860
Band A 5865 5845 5825 5805 5785 5765 5745 5745
RaceBand 5732 5732 5732 5769 5806 5843 5843 5843
Band B 5733 5752 5771 5790 5809 5828 5847 5866
Using the Video Transmitter
LEDs
Adjusting the FPV Camera Angle
Consult local laws and ordinances before operating FPV equipment. In some
areas, FPV operation may be limited or prohibited. You are responsible for
operating this product in a legal and responsible manner.
See the Available Frequency table to fi nd the desired video channel and
band. The video transmitter channel and band are changed using the button
on the top of the video transmitter board, as shown. There are two rows of
LEDs visible on the board. The inner row of red LEDs indicates the channel
selected (1-8). The outer row of blue LEDs indicate the selected band
(F, E, A, R, B). The bottom green LED indicates if the board is transmitting.
IMPORTANT: The 25mW video transmitter included with the European
Union version of the Theory XL (SPMVT2502) has 4 blue LEDs.
Band E is not available on this version.
Only change the video channel and band when the video transmitter is not trans-
mitting a signal. If the green LED is glowing solid, see the directions below to stop
transmitting a video signal prior to changing the channel or band.
Channel Selection:
1. With the video transmitter powered on, press the the channel button
once per channel to cycle through the channels.
2. The current channel (1–8) is indicated by which channel LED is lit.
Band Selection:
1. With the video transmitter powered on, press the channel button quickly
twice to change the band.
2. The current band (F, E, A, R, B) is indicated by which band LED is lit.
Video Signal on/off:
1. Press and hold the channel button for 2 seconds to start transmitting a video signal, indicated by the green LED glowing solid.
2. Press and hold the channel button for 2 seconds to stop transmitting a video signal, indicated by the green LED turning off.
Available Frequencies, North America (mHz)
The angle of the FPV camera is adjusted by loosening the
two screws holding the camera to the mount and rotating the
camera to the desired angle. Tighten the screws to secure
the camera. Do not overtighten the screws as damage to the
camera or mount may result.
Available Frequencies, European Union (mHz)
Video Transmitter LEDs
Channels
1-8
Bands*
Channel
button
* The 25mW video transmitter included in the EU
version of the Theory XL does not include band E
and only has 4 band LEDs.