Blade Theory Type W Manual - US

5
EN
Airframe Assembly
NOTICE: When using cyanoacrylate (CA) adhesive to join or repair the airframe, DO NOT allow the adhesive to contact or get close to the fpv camera lens. The vapors
from the adhesive will permanently fog the camera lens.
Prior to beginning assembly, inspect all of the foam parts. Using a hobby knife or sandpaper, remove any excess fl ash or rough edges.
Install the Spar
1. Slide the wing spar through the center
section until it is centered.
Inspect the Wings
Prior to installing the wings every time, particularly after a crash or hard
landing, inspect the wing alignment pins and pockets for any damage. If
the pins or pockets are damaged, repair or replace the wing panels prior
to attempting to fl y.
Install the Wings
1. Slide the wing panel partially onto the wing spar.
2. Connect the elevon servo connector to the port in the center section.
3. Slide the wing fully onto the wing spar, lining up the wing alignment
pins with the holes in the center section. Be careful to not trap the
servo wire in the wing joint. The patent pending wing lock mechanism
will click when the wing is fully seated.
4. Repeat for the opposite wing.
To Remove the Wings
1. Press the wing lock mechanism while carefully pulling the wing away
from the center section.
2. Disconnect the elevon servo connector from the center section.
3. Pull the wing section off of the wing spar.
4. Remove the opposite wing in the same manner.
5. Remove the wing spar if desired.
Wing Alignment Pins
Wing Alignment Pins