BLH04150 Scimitar Quadcopter Manual

9
EN
To bind or re-bind your quadcopter to your chosen transmitter, follow the directions below.
Transmitter and Receiver Binding
If you encounter problems, obey binding instructions and refer to the troubleshooting guide for other
instructions.
If needed, contact the appropriate Horizon Product Support office. For a list of compatible DSM
®
transmitters, please visit www.bindnfly.com.
Failsafe
The included receiver does not have failsafe capabilities. Failsafe is detected at the flight controller. In
the event of a loss of signal to the receiver the flight controller will cut power to the motors to prevent a
fly-away situation.
Binding Procedure
1. Disconnect the flight battery from the quadcopter.
2. Set the model type in your transmitter settings to “Acro” mode.
3. Center all trims on your transmitter.
4. Power off the transmitter and fully lower the throttle.
5. Connect the flight battery in the quadcopter. The orange LED on the receiver will flash rapidly,
indicating the aircraft has entered bind mode.
6. Put the transmitter into bind mode while powering on the transmitter.
7. Release the bind button/switch after 2–3 seconds. The quadcopter is bound when the orange
LED on the receiver turns solid.
8. Disconnect the flight battery and power the transmitter off.