BLH04150 Scimitar Quadcopter Manual

20
EN
Problem Possible Cause Solution
Difficulty binding
Bind button not pressed while
powering on the quadcopter
Power off quadcopter and repeat bind process
Bind switch or button was not held
while transmitter was powered on
Power off transmitter and repeat bind process
Transmitter too near aircraft during
binding process
Power off the transmitter. Move the transmitter
a larger distance from the aircraft or shield the
aircraft from the transmitter using your body.
Disconnect and reconnect the flight battery to
the quadcopter. Follow the binding instructions
Quadcopter or transmitter is too close
to large metal object, wireless source
or another transmitter
Move quadcopter and transmitter to another
location and attempt binding again
Difficulty connecting
(after binding)
Transmitter not powered on before the
quadcopter
Power the quadcopter off. Power on the
transmitter first and then the quadcopter.
Less than a 5-second wait between
first powering on the transmitter and
connecting the flight battery to the
quadcopter
Leave the transmitter powered on.
Disconnect and reconnect the flight
battery to the quadcopter
The quadcopter is bound to
a different model memory
(ModelMatch
™
transmitters only)
Select the correct model memory on the
transmitter. Disconnect and reconnect the flight
battery to the quadcopter
Flight battery or transmitter battery
charge is too low
Replace or recharge batteries
Quadcopter or transmitter is too close
to large metal object, wireless source
or another transmitter
Move quadcopter and transmitter to another
location and attempt connecting again