BLH04150 Scimitar Quadcopter Manual

16
EN
•In air mode (switch position 1), the quadcopter will not self-level and does not have a bank angle limit. At low
throttle, the flight controller will continue to stabilize the quadcopter to hold whatever attitude was last com-
manded. This mode is useful for flying smooth aerobatic maneuvers at both high and low throttle settings.
•In acro mode (switch position 2 ), the quadcopter will not self-level and does not have a bank angle limit. At
low throttle, the flight controller will not stabilize the quadcopter. The pilot must actively control the quad-
copter to maintain a desired attitude. This mode is most preferred when immediate changes in altitude are
desired, such as in racing. Use rates and expo to tune the performance according to your flying style.
Refer to the Transmitter Setup for transmitter switch selection and specific setup information.
Preparing the Scimitar Quadcopter for Flight
1. Before each flight, ALWAYS power on the transmitter before connecting the flight battery to the
quadcopter. After each flight, disconnect the flight battery from the quadcopter before powering off
the transmitter.
NOTICE: Connecting the flight battery before powering on the transmitter can start the binding pro-
cess. Please see the Transmitter and Receiver Binding section of this manual for more information.
2. When the ESC beeps, the flight controller is initialized and ready for flight.
The flight controller will not arm the motors until the throttle stick is in the lowest possible position.
Flight Mode and Rate Selection