BLH04150 Scimitar Quadcopter Manual

Consult local laws and ordinances before operating FPV equipment. In some areas, FPV operation may be

limited or prohibited. You are responsible for operating this product in a legal and responsible manner.

See the Available Frequency table to ﬁnd the desired video channel and band.

Using the Video Transmitter

The video transmitter channel and band are changed

using the button on the top of the quadcopter, as shown.

There are eight LEDs on the video transmitter board. The

ﬁrst two LEDs indicate the power setting, the red LED is

the channel indicator, and the next ﬁve blue LEDs are the

band indicators.

Power Output Selection:

1. Press and hold the button for ﬁve seconds to

change the power output. 25mW is indicated by the

ﬁrst green LED glowing solid. 150mW is indicated

by the second green LED glowing solid. RF output

is off when the green LEDs are not illuminated.

Channel Selection:

2. Channel 1 is indicated by the red LED

glowing solid.

3. Press the button to cycle through the channels

(1-8). The red LED will ﬂash once as you cycle

through each channel. Press the button once for each channel until the desired channel is reached.

If unsure of the current transmitter channel, press the button to cycle the channels until you reach

channel 1, indicated by a solid red LED, then cycle to the channel desired.

Band Selection:

1. Press and hold the button for two seconds to change the video transmitter band.

2. When the band changes, the blue LEDs indicate the selected band. The blue LEDs indicate FS/IRC

band, band E, band A, race band and band B, in that order as shown in the illustration.

LED window

Video Transmitter LEDs

Channel

Band

150mW

25mW