Ozone RTF BNF Basic Manual

Installing the Transmitter Batteries (RTF)

Replace the transmitter batteries when the power LED ﬂ ashes and the

transmitter beeps.

1. Lower the throttle to the lowest setting. For BNF aircraft, engage throttle hold if your transmitter is so equipped.

2. Power on the transmitter.

3. Install the battery by sliding it into the battery mounting slot below the control unit. Slide the battery into the slots

with the label facing upward so that the battery key molded into the battery end-cap comes in contact with

the key on the battery slot.

4. Connect the battery cable to the control unit.

5. Place the quadcopter on a ﬂ at surface and leave the aircraft still until the LED on the control unit indicates one of the

following ﬂ ight modes:

Solid green: Stability Low Bank Angle mode, switch position 0

Solid blue: Stability High Bank Angle mode, switch position 1 (Not applicable with RTF transmitter. BNF only, if your

transmitter is equipped with a 3-position switch)

Solid red: Agility mode, switch position 2

CAUTION: Always disconnect the Li-Po battery from the aircraft when not ﬂ ying to avoid over-discharging the

battery. Batteries discharged to a voltage lower than the lowest approved voltage may become damaged,

resulting in loss of performance and potential ﬁ re when batteries are charged.

Installing the Flight Battery

ansmitter is so equipped