Blade mCP S Manual

5
EN
Installing the Transmitter Batteries (RTF)
The LED indicator fl ashes and the transmitter
beeps progressively faster as the battery voltage
drops.
Replace the transmitter batteries when the
transmitter begins to beep.
Transmitter Control (RTF)
D
E
C
B
Flight mode switch
E
Dual rate
switch
ABCDE F
Mode 1
Aileron (Left/Right)
Throttle/Collective
(Up/Down)
Throttle
Trim
Aileron
Trim
Rudder
Trim
Elevator
Trim
Rudder (Left/Right)
Elevator (Up/Down)
Mode 2
Aileron (Left/Right)
Elevator (Up/Down)
Elevator
Trim
Aileron
Trim
Rudder
Trim
Throttle
Trim
Rudder (Left/Right)
Throttle/Collective
(Up/Down)
ON/OFF
Switch
A
F
Adjusting Flight Trims
When pressed down, trim buttons make a sound that
increases or decreases in pitch at each pressing. The
middle or neutral trim position is heard as a middle tone in
the pitch range of the sounds. The end of the control range
is sounded by a series of beeps.
Dual Rate Selection
The control sensitivity can be changed by pressing and
releasing the right control stick. The LED on the transmitter
will show solid for high sensitivity (default) and fl ashing for
low sensitivity.
Bind switch
Panic Recovery
Power LED/fl ight
mode indicator