BLH9800 Inductrix Switch Manual

9
EN
Takeo
Increase the throttle until the model is approximately 2 ft. (600mm) off the ground and check the trim so the model
fl ies as desired. Once the trim is adjusted, begin fl ying the model.
Typical fl ight times for the included battery range from 3 to 4 minutes.
Low Voltage Cuto (LVC)
LVC decreases the power to the motors when the battery voltage gets low. When the motor power decreases and the
front and rear FC LEDs fl ash red, land the aircraft immediately and recharge the fl ight battery.
LVC does not prevent the battery from over-discharge during storage.
NOTICE: Repeated fl ying to LVC will damage the battery.
Landing
To land, slowly decrease the throttle while in a low-level hover. After landing, hold the arm/disarm switch until the
motors have stopped, then remove the battery. Fully charge your battery before storing it. During storage, make sure the
battery charge does not fall below 3V per cell.
Flying the Switch Quadcopter
To select Mode 1, press both sticks down and in for 10 seconds. The fl ight mode LED will glow
green to indicate Mode 1, Single stick operation. In Mode 1, the left stick is not used and the
right stick controls both throttle and drectional movement, as shown below.
Hovercra Operation (Mode 1 - Single Stick Operation)
Switching from Quadcopter Operation to Hovercra Operation
To switch from quadcopter operation to hovercraft operation, slide the two rear fans down out of the clips on the main
frame and slide them into the clips at the rear of the hovercraft base plate. Seat the main frame into the slot in the base
plate with the two front fans attached ensuring the fans click into their respective openings in the base plate.
Aileron - Right stick
Aileron left
Aileron right
Nose Yaws Left Nose Yaws Right
Elevator - Right stick
Elevator down
Elevator up
Left Side View
Top View Top View
Left Side View
Lift Brake
Forward
Slow down/
Coast