BLH9800 Inductrix Switch Manual

Revolutionary SAFE

(Sensor Assisted Flight Envelope) technology uses an innovative combination of multi-axis sensors and

software that allows model aircraft to know its position relative to the horizon. This spatial awareness is utilized to create a

controlled ﬂ ight envelope the aircraft can use to maintain a safe region of bank and pitch angles so you can ﬂ y more safely.

Far beyond stability, this level of protection offers multiple modes so the pilot can choose to develop his or her skills with a

greater degree of security and ﬂ ight control that always feels crisp and responsive.

SAFE technology delivers:

• Flight envelope protection you can enable at the ﬂ ip of a switch.

• Multiple modes let you adapt SAFE technology to your skill level instantly.

Best of all, sophisticated SAFE technology doesn’t require any work to enjoy. Every aircraft with SAFE installed is ready to use

and optimized to offer the best possible ﬂ ight experience.

FlySAFERC.com

Technology

MLP4DSM Binding Procedure

1. Disconnect the ﬂ ight battery from the quadcopter.

2. Center all trims on your transmitter.

3. Power off the transmitter and move the throttle stick to the down/off position.

4. Connect the ﬂ ight battery in the quadcopter. The LED on the control unit ﬂ ashes after 5 seconds.

5. When the blue light is ﬂ ashing, push in and hold down the left stick* while powering on the transmitter

(you will hear a ‘click’).

6. Release the left stick. The transmitter will beep and the power LED will blink.

7. The quadcopter is bound when all of the LEDs on the aircraft turn solid.

8. Disconnect the ﬂ ight battery and power the transmitter off.

* The trigger switch may also be used for the binding procedure.

If you encounter problems, obey binding instructions and refer to the troubleshooting guide for other instructions.

If needed, contact the appropriate Horizon Product Support ofﬁ ce. For a list of compatible DSM

transmitters, please

visit www.bindnﬂ y.com.

RTF

Your RTF transmitter comes prebound to the model. If you need to re-bind, follow the directions below.

Transmitter and Receiver Binding