BLH9800 Inductrix Switch Manual

10
EN
Post-Flight Inspection and Maintenance Checklist
√
Cleaning
Make sure the battery is not connected before cleaning. Remove dust and debris with a soft brush or
a dry, lint-free cloth.
Motors Replace the motor when the model will not fl y steady or veers off when doing a climb out.
Wiring Make sure the wiring does not block moving parts. Replace damaged wiring and loose connectors.
Fasteners
Make sure there are no loose screws, other fasteners or connectors. Do not over-tighten metal
screws in plastic parts. Tighten screws so the parts are mated together, then turn the screw only
1/8th of a turn more.
Propellers
Make sure there is no damage to the propellers or other parts that move at high speed. Damage to
these parts includes cracks, burrs, chips or scratches. Replace damaged parts before fl ying.
Hovercra (Mode 2 - Two Stick Operation)
Throttle - Le stick
Forward
Throttle forward
Throttle back
Slow down/Coast
Left Side View Left Side View
Rudder - Le stick
Rudder left
Rudder right
Nose Yaws Left Nose Yaws Right
To select Mode 2, press both sticks up and in for 10 seconds. The fl ight mode LED will glow
amber to indicate Mode 2, two stick operation. In Mode 2, the right stick controls lifting fans
only and all directional movement is controlled by the left stick, as shown below.
Elevator - Right stick
Elevator down
Elevator up
Left Side View
Top View Top View
Left Side View
Lift
Brake