Inductrix FPV + Manual

22
EN
The LEDs indicate the front and back of the quadcopter. The white LEDs
indicate the front. The red LEDs and tail light indicate the back.
Takeo
Arm the motors by pressing the arming switch. Increase the throttle until
the model is approximately 2 ft. (600mm) off the ground in a low-level
hover and concentrate on balancing the throttle stick’s position so that the
quadcopter holds a steady hover altitude. In some cases, you may need to
make a few short “hops” to an altitude of just a few inches until you be-
come familiar with the control inputs and trim settings required to maintain
a steady hover and altitude.
Hovering
The Inductrix
®
quadcopter requires minor throttle adjustments to maintain its
altitude in hover. Remember to keep these throttle adjustments as minimal as
possible. Large adjustments could result in a loss of control or a possible crash.
While attempting to establish a low-level hover, check to see if any trim
adjustments are required to keep the quadcopter from drifting in various
directions. If you nd that it constantly drifts without any directional control
input, land the model before making any adjustments to the trim settings.
•If the nose of the quadcopter rotates to the left or right, adjust the
rudder trim in the opposite direction.
Fly the Quadcopter