Inductrix FPV + Manual

If you encounter problems binding either the included RTF transmitter

or your computer radio, obey the binding instructions and refer to the

troubleshooting guide for other instructions. If needed, contact the

appropriate Horizon Product Support ofce.

Your RTF transmitter comes prebound to the quadcopter. If you need to

re-bind, follow the directions below.

MLP6DSM Binding Procedure (RTF)

1. Disconnect the ight battery from the quadcopter.

2. Center all trims on your transmitter.

3. Power off the transmitter and fully lower the throttle.

4. Connect the ight battery in the quadcopter. All of the LEDs on the

aircraft will ash rapidly, indicating the aircraft has entered bind mode.

5. Push in and hold down the left stick while powering on the transmitter

(you will hear a ‘click’ and a long tone).

6. Release the left stick. The transmitter will beep and the power LED

will blink. The quadcopter is bound when all of the LEDs on the

aircraft turn solid.

7. Disconnect the ight battery and power the transmitter off.