User Manual

15
EN
The LEDs indicate the front and back of the quadcopter. The white LEDs
indicate the front. The red LEDs and tail light indicate the back.
Takeo
Arm the motors by pressing the arming switch. Increase the throttle
until the model is approximately 2 ft. (600mm) off the ground in a low-
level hover and concentrate on balancing the throttle stick’s position so
that the quadcopter holds a steady hover altitude. In some cases, you
may need to make a few short “hops” to an altitude of just a few inches
until you become familiar with the control inputs and trim settings
required to maintain a steady hover and altitude.
Hovering
The Inductrix
®
quadcopter requires minor throttle adjustments to
maintain its altitude in hover. Remember to keep these throttle
adjustments as minimal as possible. Large adjustments could result in
a loss of control or a possible crash.
While attempting to establish a low-level hover, check to see if any
trim adjustments are required to keep the quadcopter from drifting
in various directions. If you nd that it constantly drifts without any
directional control input, land the model before making any adjustments
to the trim settings.
•If the nose of the quadcopter rotates to the left or right, adjust the
rudder trim in the opposite direction.
Fly the Quadcopter