Inductrix 200 Manual-MULTI

6
EN
Servo Setup
FUNCTION LISTSYSTEM SETUP
DX7s
D/R & Expo
Chan Switch Pos (FLAP) D/R Expo*
AILE
0 100/100 0
1 100/100 0
2 75/75 0
ELEV
0 100/100 0
1 100/100 0
2 75/75 0
RUDD
0 100/100 0
1 100/100 0
2 75/75 0
Timer
Mode Count Down
Time 5:00 Tone
Start Throttle Out
Pos 25%
Chan Travel Reverse
THR 100/100 Normal
AIL 100/100 Normal
ELE 100/100 Normal
RUD 100/100 Normal
Chan Travel Reverse
GER 100/100 Normal
AX1 100/100 Reverse
AX2 100/100 Normal
Model Type ACRO
SW Select
Trainer Aux 1
Flap Gear
All Others INH
Motor Stop
Bind / I Button
Pressed (~1 sec) = Motor Stop
Motor Stop
Flap Switch
Pos 0 = Normal
Pos 1 = Motor Stop
* Use of "Expo" is not necessary for successful fl ight of the Inductrix 200. The pilot may adjust this setting to tailor the
sensitivity of the quadcopter around neutral if desired.
D/R & Expo
Chan Sw Pos D/R Expo*
AILE
0 100 INH
1 75 INH
ELEV
0 100 INH
1 75 INH
RUDD
0 100 INH
1 75 INH
Timer
Down Timer 5:00
Switch THR CUT
ADJUST LISTSETUP LIST
DX6i
TRAVEL ADJ
Channel Travel
THRO 100/100
AILE 100/100
ELEV 100/100
RUDD 100/100
GEAR 100/100
FLAP 100/100
REVERSE
Channel Direction
THRO N
AILE N
ELEV N
RUDD N
GEAR R
FLAP N
Modulation Type
AUTO DSMX-ENABLE
D/R COMBI
D/R SW AILE
Model Type Acro
Flight Mode Operation
Gear Sw: Pos 0, Elev D/R Sw: 0 or 1 = Stability, Low-Angle Mode (quadcopter LED Blue)
Gear Sw: Pos 1, Elev D/R Sw: 0 = Stability, High-Angle Mode (quadcopter LED Green)
Gear Sw: Pos 1, Elev D/R Sw: 1 = Agility Mode (quadcopter LED Red)
Flight Mode Operation
FLAP Sw: Pos 0 = Stability, Low-Angle Mode (quadcopter LED Blue)
Pos 1 = Stability, High-Angle Mode (quadcopter LED Green)
Pos 2 = Agility Mode (quadcopter LED Red)
Mixing
MIX 1 ACT
GEAR > GEAR ACT
RATE D 0% U –100%
SW GEAR TRIM – INH
MIX 2 ACT
GEAR > GEAR ACT
RATE D 0% U +100%
SW ELE D/R TRIM – INH
FLAPS
FLAP ELEV
NORM 100 0
LAND 100 0