Instruction Manual Bedienungsanleitung Manuel d’utilisation Manuale di Istruzioni ®
EN NOTICE All instructions, warranties and other collateral documents are subject to change at the sole discretion of Horizon Hobby, LLC. For up-to-date product literature, visit www.horizonhobby.com and click on the support tab for this product.
EN Table of Contents Safety Precautions and Warnings .......................2 Table of Contents ...............................................3 First Flight Preparation .......................................4 Flying Checklist..................................................4 Installing the Propellers ......................................4 Assembly ..........................................................4 Transmitter Setup...............................................5 Installing the Flight Battery .
EN First Flight Preparation Flying Checklist • Remove and inspect contents • Begin charging the flight battery • Assemble the aircraft • Program your computer transmitter • Install the flight battery in the aircraft (once it has been fully charged) • Bind your transmitter • Familiarize yourself with the controls • Find a suitable area for flying ❏ Always turn the transmitter on first ❏ Plug the flight battery into the lead from the ESC ❏ Allow the ESC to initialize and arm properly ❏ Fly the model ❏ Land the
EN Transmitter Setup DX6, DX6e, DX7 (Gen 2), DX8 (Gen 2), DX9, DX18, DX20 FUNCTION LIST SETUP LIST Model Type Airplane F-Mode Setup Switch 1 Switch 2 Inhibit Inhibit Channel Assign Channel Input Config 1 Throttle 2 Aileron 3 Elevator 4 Rudder 5 Gear Switch B 6 Aux 1 Switch H Frame Rate 11ms* DSMX Servo Setup Chan THR AIL ELE RUD GER AUX1 Travel 150/150 148/148 148/148 148/148 100/100 100/100 D/R & Expo Chan Switch Pos 0 AILE 1 2 0 ELEV 1 2 Reverse Normal Reverse Normal Reverse Normal Normal D/R 100/10
EN Transmitter and Receiver Binding To bind or re-bind your quadcopter to your chosen transmitter, follow the directions below. Binding Procedure 1. Select the correct model in your transmitter. 2. Power off your transmitter. 3. Lower the throttle fully. 4. Power the quadcopter on while pressing the bind button located on the left side of the flight control board, as shown in the illustration. Do not press the button on the right side of the flight board. 5.
EN Using the Video Transmitter Consult local laws and ordinances before operating FPV equipment. In some areas, FPV operation may be limited or prohibited. You are responsible for operating this product in a legal and responsible manner. See the Available Frequency table to find the desired video channel and band. The video transmitter channel and band are changed using the button on the top of the video transmitter board, as shown. There are two rows of LEDs visible on the board.
EN Preparing the Stealth Conspiracy Quadcopter for Flight 1. Before each flight, ALWAYS power on the transmitter before connecting the flight battery to the quadcopter. After each flight, disconnect the flight battery from the quadcopter before powering off the transmitter. NOTICE: Connecting the flight battery before powering on the transmitter can start the binding process. Please see the Transmitter and Receiver Binding section of this manual for more information. 2.
EN Troubleshooting Guide WARNING: Remove the propellers from the motors prior to performing any troubleshooting or maintenance. Failure to do so may cause serious injury if the motors start unexpetedly.
EN Parts Explosion 2 5 7 12 15 4 16 11 3 5 10 13 2 16 1 9 14 9 8 1 6 14 9 Parts Listings 1 2 3 4 5 6 7 8 Part # BLH02001 BLH02002BK BLH02003 BLH02004 BLH02005 BLH02006 BLH02007 BLHA1004BK Description Main Frame: Conspiracy 220 BNF Frame Skirt, Black: Conspiracy LED Board: Conspiracy 220 HD Camera Mount: Conspiracy 22 Hardware Kit: Conspiracy 220 Battery Strap: Conspiracy 220 Top Plate: Stealth Conspiracy 5x4 FPV Race Prop Set, Black 9 10 11 12 13 14 15 16 Part # BLHA1023 SPMFC3207 SPMV
EN Limited Warranty What this Warranty Covers Horizon Hobby, LLC, (Horizon) warrants to the original purchaser that the product purchased (the “Product”) will be free from defects in materials and workmanship at the date of purchase.
EN Warranty and Service Contact Information Country of Purchase Horizon Hobby Horizon Service Center (Repairs and Repair Requests) United States of America Horizon Product Support (Product Technical Assistance) Sales Contact Information servicecenter.horizonhobby.com/ RequestForm/ productsupport@horizonhobby.com 877-504-0233 websales@horizonhobby.
FR ©2017 Horizon Hobby, LLC. Blade, Conspiracy, Thrust, DSM, DSM2, DSMX, Bind-N-Fly, BNF, the BNF logo, ModelMatch, Focal and the Horizon Hobby logo are trademarks or registered trademarks of Horizon Hobby, LLC. The Spektrum trademark is used with permission of Bachmann Industries, Inc. All other trademarks, service marks or logos are property of their respective owners.
