70 S Manual

5
EN
The LED indicator fl ashes and the transmitter beeps
as the battery voltage drops.
Replace the 4 AA transmitter batteries when the
transmitter begins to beep.
Dual Rate
Switch
Adjusting Flight Trims
The transmitter beeps every time one of the trim buttons is
pressed, until the trim has reached the upper or lower range
limit. The middle or neutral trim position is heard as a longer
tone. The end of the trim range is indicated by no sound when
the button is pressed.
Dual Rate Selection
The control sensitivity can be changed by pressing and releasing
the dual rate button. The transmitter beeps once to indicate low
rates and twice to indicate high rates. The default setting when
the transmitter is powered on is low rates.
Transmitter Control
ABCDEF
Mode 1
Rudder (Left/Right)
Elevator (Up/Down)
Elevator Trim Rudder Trim Aileron Trim Throttle Trim
Aileron (Left/Right)
Throttle (Up/Down)
Mode 2
Rudder (Left/Right)
Throttle (Up/Down)
Throttle Trim Rudder Trim Aileron Trim Elevator Trim
Aileron (Left/Right)
Elevator (Up/Down)
Installing the Transmitter Batteries
C
D
B
E
A
F
ON/OFF Switch
Power LED
indicator
Programming port
Factory Use Only