User Manual

ManualsBrandsBlade ManualsHobby360 CFX BNF Basic

Low Voltage Cuto (LVC)

The ESC will continuously lower power to the motor until complete shutdown

when the battery reaches 18V under load. This helps prevent over-discharge of the

Li-Po battery. Land immediately when the ESC activates LVC. Continuing to ﬂ y after

LVC can damage the battery, cause a crash or both. Crash damage and batteries

damaged due to over-discharge are not covered under warranty.

Repeatedly ﬂ ying the helicopter until LVC activates will damage the helicopter

battery.

Disconnect and remove the Li-Po battery from the aircraft after use to prevent

trickle discharge. During storage, make sure battery charge does not fall below

3V per cell.

First Flight Preparation

• Remove and inspect contents

• Begin charging the ﬂ ight battery

• Install the ﬂ ight battery in the helicopter (once it has been fully charged)

• Program your computer transmitter

• Bind your transmitter

• Familiarize yourself with the controls

• Find a suitable area for ﬂ ying

Flying Checklist

❏ Always turn the transmitter on ﬁ rst

❏ Plug the ﬂ ight battery into the lead from the ESC

❏ Allow the ESC to initialize and arm properly

❏ Fly the model

❏ Land the model

❏ Unplug the ﬂ ight battery from the ESC

❏ Always turn the transmitter off last

Transmitter Setup

Program your transmitter before attempting to bind or ﬂ y the helicopter.

Transmitter programming values are shown below for the Spektrum DX6i,

DX7/DX7se, DX6, DX7s, DX8, DX9 and DX18.

The ﬁ les for models using Spektrum™ transmitters with AirWare™ software are

also available for download online at www.spektrumrc.com.

DX6i

SETUP LIST

Model Type

HELI

Reverse

THRO N

AILE R

ELEV R

RUDD R

GYRO N

PITC N

Swash Type

1 Servo 90

Timer

3:00

ADJUST LIST

Thro Curve

NORM 0% 30% 30% 30% 30%

STUNT 100% 100% 100% 100% 100%

HOLD 0% 0% 0% 0% 0%

Pitc Curve

NORM 30% 40% 50% 75% 100%

STUNT 0% 25% 50% 75% 100%

HOLD 0% 25% 50% 75% 100%

Travel Adj

THRO Low: 100% Hi: 110%

AILE 100%

ELEV 100%

RUDD 100%

GYRO 100%

PITC 100%

Gyro

Rate SW-F. Mode

NORM 20%

STUNT 20%

DX7/DX7se

SYSTEM LIST

Model Type

HELI

Swatch Type

1 Servo 90

FUNCTION MODE

D/R & EXP

0-AILE 100% 0%

0-ELEV 100% 0%

0-RUDD 100% INH

1-AILE 85% 0%

1-ELEV 85% 0%

1-RUDD 85% INH

Thro Curve

NORM 0% 30% 30% 30% 30%

ST-1 75% 75% 75% 75% 75%

ST-2 100% 100% 100% 100% 100%

HOLD 0% 0% 0% 0% 0%

Pitc Curve

NORM 30% INH 50% INH 100%

ST-1 0% INH 50% INH 100%

ST-2 0% INH 50% INH 100%

HOLD 0% INH 50% INH 100%

Travel Adj

THRO Low: 130% Hi: 110%

AILE 100%

ELEV 100%

RUDD 100%

GEAR 100%

PIT. 100%

Reversing SW

THRO N RUDD R

AILE R GEAR N

ELEV R PIT. R

Gyro SENS

AUTO F.MODE

STNT 20%

HOLD 20%

Timer

3:00

DX6/DX7s/DX8/DX9/DX18

SYSTEM SETUP

Model Type

HELI

Swash Type

1 Servo Normal

F-Mode Setup

Flight Mode: F Mode

Hold: Hold

Frame Rate

22ms

DSMX

FUNCTION LIST

D/R & Expo

0-AILE 100% 0%

0-ELEV 100% 0%

0-RUDD 100% 0%

1-AILE 85% 0%

1-ELEV 85% 0%

1-RUDD 85% 0%

2-AILE 85% 0%

2-ELEV 85% 0%

2-RUDD 85% 0%

Throttle Curve

NORM 0% 30% 30% 30% 30%

ST-1 75% 75% 75% 75% 75%

ST-2 (DX6, 8, 9, 18) 100% 100% 100% 100% 100%

HOLD 0% 0% 0% 0% 0%

Pitch Curve

NOR 30% 40% 50% 75% 100%

ST-1 0% 25% 50% 75% 100%

ST-2 (DX6, 8, 9, 18) 0% 25% 50% 75% 100%

HOLD 0% 25% 50% 75% 100%

Reverse

THRO N

AILE R

ELEV R

RUDD R

GEAR N

PIT. R

Timer

MODE Countdown

TIME 3:00 Tone/Vibe

START Throttle Cut

POS 25

Gyro

SW F Mode

CH Gear

NORMAL/POS 0 58%

STUNT 1/POS 1 48%

STUNT 2/POS 2 40%

HOLD 58%

SERVO SETUP

Travel

THRO Low: 130% Hi: 110%

AILE 100%

ELEV 100%

RUDD 100%

GEAR 100%

PIT. 100%