Instruction manual

8
EN
Binding
TheRTF/APcombotransmitterisboundtothemodel
atthefactory.Ifforanyreasonthemodelneedstobe
re-bound,followthedirectionsbelow.
NormalBind
Rollleft
Rollright
BindwithGPSenabled
BindwithGPSdisabled
Bindbutton
Transmitter Bind Codes
Entering Bind Mode
Binding the 350 QX3 To Your Transmitter
1.WiththetransmitterandquadcopterpoweredOFF,
connectthebatterytothe350QX3.
2.Placethe350QX3onaatlevelsurface.
3.Powerthe350QX3ONandletitinitialize.The
statusLEDwillremainoff.
4.Holdthe350QX3upsidedownuntilthestatusLED
ashesblue,indicatingithasenteredbindmode.
5.Setthequadcopterbackupright.
6.Onyourtransmitter,ensurethethrottleisinthelow
positionandthethrottletrimisatneutral.
7.PowerONyourtransmitterinbindmodeaccording
totheinstructionsincludedwithyourtransmitter.
8.Whenthebindingprocessissuccessful,the
350QX3willemitaquick,3-beeptoneandtheLED
willasheithergreen,purpleorred,dependingon
whichightmodeisselected.
IftheLEDisashingred,the350QX3isinReturn
Homemode.SwitchtoSmartorAPMode(green
orpurpleashing)beforeattemptingtostartthe
motors.
9.Placethequadcopteroutdoorsinthedesired
startingpositioninpreparationforight.