Instruction manual

5
EN
Charging the Flight Battery
Charger Specifications
•InputVoltage:10.5–15VDC
•ChargeCurrent:3.5A
Charger LED Codes
Green Blinking:Powerconnected
Red Blinking:Charging
Red & Green Blinking:Cellsbalancing
Green Solid:Chargingcomplete
Red Solid:Error
CAUTION:Allinstructionsandwarningsmust
befollowedexactly.MishandlingofLi-Po
batteriescanresultinare,personalinjuryand/or
propertydamage.
NOTICE:Ifusingabatteryotherthantheincluded
Li-Pobattery,refertoyourbatterymanufacturer’s
instructionsforcharging.
1a 1b
2 3
Install the Gimbal (AP Combo)
Install the Transmitter Batteries (RTF, AP Combo)
The Battery Charging Process
1.ConnecttheACpowersupplytothecharger.
2.ConnecttheACpowersupplytoanACpowersource.
ThegreenLEDblinks.
3.Connectthebatterytothecharger.TheredLED
blinks,indicatingcharging.Whenthebatterynears
fullcharge,theredandgreenLEDsblink,indicating
cellbalancing.
4.DisconnectthebatterywhenthegreenLEDglows
solid.
•Slidethegimbalonthemountrailsuntilitlocks.
•Connectthewiringharnesstotheplugonthebottom
ofthe350QX3.
•Toremovethegimbal,pressthetabatthefrontof
themountandslidethegimbalforward.
•Install4AAbatteriesinthetransmitterasshown.
b
a