User Manual

ManualsBrandsBlade ManualsHobby350 QX RTF with SAFE Technology

Return Home

• When this feature is activated, the 350 QX will

ﬂ y back to its assigned home location and

land. After landing, the motors may take up to

5 seconds to disarm. If the motors take more

than 20+ seconds to disarm, perform the

Pressure Sensor Calibration.

• To restart the props after landing in Return Home,

fully lower the throttle and ensure the throttle trim is

neutral, then quickly move the rudder stick fully left

and then fully right.

CAUTION: The 350 QX will not recognize the

SAFE Circle feature when Return Home is

used. Activating Return Home may cause the 350 QX

to ﬂ y directly over the pilot if the aircraft was ﬂ own to

a position behind where the pilot was standing when

the home position was established.

TRAINER

Activating Return Home

Press and hold.

Releasing the switch

will stop the Return Home

program.

Landing

To land the 350 QX there are two options:

• Guide the aircraft to where you wish to land and

reduce the throttle. Reduce the throttle trim after

landing to disarm the motors.

• Activate the Return Home function to return the

350 QX to the assigned home location and land

automatically.

CAUTION: Do not activate the Return Home

function if the 350 QX is showing the low

battery indication. Manually land the aircraft

immediately.

After Your Flight

1. Turn off the power switch on the 350 QX.

2. Turn off the power to your transmitter.

3. Unplug and remove the battery from the 350 QX.

CAUTION: Always disconnect the Li-Po bat-

tery from the aircraft when not ﬂ ying to avoid

over-discharging the battery. Batteries discharged to a

voltage below the lowest approved voltage may become

damaged, resulting in loss of performance and potential

ﬁ re when batteries are charged.

Location alert

The motors will Beep under the following conditions:

• At any time the props stop spinning after they have

been initialized.

• After 30 seconds of no throttle input (waiting armed

on the ground).

This will alert the pilot to the location of the aircraft if it

lands in a location with low visibility.

Beeping will continue until the battery can no longer

supply enough power to the motors.

If the quadcopter crash lands and one or more motors

are stopped by an impact, the quadcopter enters

emergency mode. The LED will ﬂ ash white and the

motors will beep loudly.