User Manual

Binding

If you purchased the ready-to-ﬂ y (RTF) model, the transmitter is bound to the model at the factory. If for any reason the

model needs to be re-bound, follow the Bind-N-Fly

(BNF) directions below.

To bind or re-bind your 350 QX to your chosen DSM2/DSMX transmitter, please follow the directions

below along with the binding instructions included with your transmitter:

The Binding Process

1. With the transmitter powered off, connect the

battery to the 350 QX.

2. With the 350 QX on a level surface, turn on

the power switch and allow the quadcopter to

initialize.

3. Wait until the blue LED on the quad ﬂ ashes

rapidly, signaling the quadcopter is initialized

and ready to bind.

4. Turn on the transmitter in bind mode.

Mode 2 shown

Normal Bind

Bind with GPS enabled Bind with GPS disabled

TRAINER

Bind switch

(Trainer switch)

When the 350 QX is bound it needs to see neutral elevator and aileron inputs. If the aircraft receives any input other

than neutral, it will emit a constant rapid beeping sound.

Please follow this procedure if your 350 QX emits a constant beeping sound after binding:

1. Ensure all trims are neutral

2. Slowly move the elevator stick back and forth close to center and listen for the beeping to stop or hesitate, take

note of the direction you are moving the stick when the change of tone happens

3. If the tone never changes with elevator movement, slowly move the aileron stick back and forth close to center

and listen for the beeping to stop or hesitate, take note of the direction you are moving the stick when the change

of tone happens

4. Input trim in the direction that caused the change in tone until the beeping stops

In the event you cannot ﬁ nd an input that stops the tones:

1. Apply 1 click of elevator trim and then slowly move the aileron stick close to center.

2. Continue to add 1 click at a time of elevator trim, up to 5 trim steps off center, and move the aileron stick

until you ﬁ nd the point that makes the tones stop.

3. Add aileron trim in the direction you moved the stick to make the tones stop.

NOTICE: Always bind with the th rottle trim at

neutral.

Refer to the LED Codes table to ensure the aircraft is bound correctly.

If the 350 QX fails to bind, turn off the power to the quad and the transmitter and repeat steps 2-4 above.

Roll left

Roll right