User Manual

8
EN
Transmitter Model
Type
Reverse Setup
Mode Setup Switch Positions
Throttle Cut
Camera Operation Dual
Rate Switch
High Rate
Low Rate
DX4e (New) w/ 3 Position Switch
N/A N/A N/A
Channel 5 (0) = Stability Mode, Low Angle
Lower throttle trim until mo- tors stop turning
Still Mode(Default) Press Trainer = Take Picture Video Mode Press Trainer = Start/Stop Recording Press & Hold Trainer for 4 Seconds = Change Modes
Rate
100% Fixed
70% Fixed
Channel 5 (1) = Stability Mode, High Angle Channel 5 (2) = Agility Mode
DX5e (New) w/ 3 Position Switch
N/A N/A N/A
Channel 5 (0) = Stability Mode, Low Angle
Lower throttle trim until mo- tors stop turning
Still Mode(Default) Press Trainer = Take Picture Video Mode Press Trainer = Start/Stop Recording Press & Hold Trainer for 4 Seconds = Change Modes
Rate
100% Fixed
70% Fixed
Channel 5 (1) = Stability Mode, High Angle Channel 5 (2) = Agility Mode
DX6i Acro
GEAR - R All Others - N
Setup List: Throttle Cut – ACT Travel Adj: GEAR (0)↑ 100%; F MODE (1) ↓40% FLAPS: Norm ←↑100; LAND ↓100
MIX 1: ACT; Gear → Gear ACT
RATE D 0% U + 100% SW MIX TRIM INH
GEAR (0); Mix (0) = Stability Mode, Low Angle
Press throttle cut
Still Mode(Default) FLAP 0-1-0 = Take Picture Video Mode FLAP 0-1-0 = Start/Stop Recording FLAP Pos 0-1(4 Sec- onds)-0 = Change Modes
ELEV-AIL D/R
100% 70%
GEAR (1); Mix (0) = Stability Mode, High Angle GEAR (1); Mix (1) = Agility Mode
DX7/7SE Acro
FLAP - R (6) All Others - N
Travel Adj: GEAR (0)↑ 100%; GEAR (1) ↑40% MIX 1: FLAP → Gear OFF/ON RATE → -50% 0% SW: MIX OFFSET: 0
GEAR (0); Mix (0) = Stability Mode, Low Angle
Lower throttle trim until mo- tors stop turning
Still Mode(Default) FLAP 0-1-0 = Take Picture Video Mode FLAP 0-1-0 = Start/Stop Recording FLAP Pos 0-1(4 Sec- onds)-0 = Change Modes
ELEV-AIL D/R
100% 70%
GEAR (1); Mix (0) = Stability Mode, High Angle GEAR (1); Mix (1) = Agility Mode