User Manual

To bind or re-bind your quadcopter to your chosen transmitter, please follow the directions below.

General Binding Procedure

1. Disconnect the ﬂ ight battery from the quadcopter.

2. Select a clean model memory on your transmitter (computer radios only).

3. Select Acro or Airplane model type on your transmitter.

4. Make sure all servo reversing is set correctly for your radio. Refer to the Transmitter Setup Table.

5. Center all trims on your transmitter.

6. Power off the transmitter and move all switches to the 0 position. Move the throttle to the low/off position.

7. Connect the ﬂ ight battery in the quadcopter. The blue LED on the 4-in-1 control unit ﬂ ashes after 5 seconds.

8. Put the transmitter into bind mode while powering on the transmitter.

9. Release the bind button/switch after 2–3 seconds. The quadcopter is bound when the blue LED on the 4-in-1

control unit turns solid.

10. Disconnect the ﬂ ight battery and power the transmitter off.

CAUTION: When using a Futaba

transmitter with a Spektrum™ DSM2

/DSMX

module, you must reverse

the throttle channel and re-bind. Refer to your Spektrum module manual for binding and failsafe instructions.

Refer to your Futaba transmitter manual for instructions on reversing the throttle channel.

If you encounter problems, obey binding instructions and refer to the troubleshooting guide for other instructions.

If needed, contact the appropriate Horizon Product Support ofﬁ ce. For a list of compatible DSM

transmitters,

please visit www.bindnﬂ y.com.

Revolutionary SAFE™ (Sensor Assisted Flight Envelope) technology uses an innovative combination of multi-axis sensors

and software that allows model aircraft to know its position relative to the horizon. This spatial awareness is utilized to

create a controlled ﬂ ight envelope the aircraft can use to maintain a safe region of bank and pitch angles so you can ﬂ y

more safely. Far beyond stability, this level of protection offers multiple modes so the pilot can choose to develop his or

her skills with a greater degree of security and ﬂ ight control that always feels crisp and responsive.

SAFE technology delivers:

• Flight envelope protection you can enable at the ﬂ ip of a switch.

• Multiple modes let you adapt SAFE technology to your skill level instantly.

Best of all, sophisticated SAFE technology doesn’t require any work to enjoy. Every aircraft with SAFE installed is ready to

use and optimized to offer the best possible ﬂ ight experience.

FlySAFERC.com

Technology

™

Transmitter and Receiver Binding

• In stability low angle mode, the controls provide a minimum bank angle. This mode is shown by the ﬂ ight control board

on the quadcopter glowing solid green.

• In stability high angle mode, the controls provide for a maximum bank angle. This mode is shown by the ﬂ ight control

board on the quadcopter glowing solid blue.

• Agility mode is shown by the ﬂ ight control board on the quadcopter glowing solid red.

Refer to the Transmitter Setup Table for which switch on your transmitter selects ﬂ ight modes and speciﬁ c setup information.

Flight Mode and Rate Selection