User Manual

Battery Charging

NOTICE: Charge only batteries that are cool to the

touch and are not damaged. Look at the battery to

make sure it is not damaged e.g., swollen, bent,

broken or punctured.

1. Connect the AC power supply to the charger.

2. Connect the other end of the power supply to an

appropriate AC power source.

3. Connect the battery balance lead to the charger

adapter (A).

4. Connect the charger adapter to the charger (B).

5. Press the Start/Stop Button to begin charging.

6. Battery charging is complete when the charger

LED is solid green.

7. Always disconnect the ﬂ ight battery from the charger immediately upon completion of charging.

Charging a fully discharged (not over-discharged) 800mAh battery takes approximately 60 minutes.

CAUTION: Only use chargers speciﬁ cally designed to charge the included Li-Po battery. Failure to do so could

result in ﬁ re, causing injury or property damage.

CAUTION: Never exceed the recommended charge rate.

LED Indications

Flashing Green LED with power connected but without battery: Standby

Flashing Green LED: Battery connected

Flashing Red LED at varying speeds: Charging

Simultaneously Flashing Red and Green LEDs: Balancing

Solid Green LED: Full Charge

Rapidly Flashing Red and Green LEDs: Error

CAUTION: Once charging is complete, immediately remove the battery.

Never leave a battery connected to the charger.

1. Lower the throttle to the lowest setting.

2. Power on the transmitter.

3. Remove the battery cover (A-C) and install the battery in the quadcopter (D).

4. Connect the battery cable to the 4-in-1 control unit (E) and replace the battery cover (F).

5. Place the quadcopter on its landing gear on a ﬂ at surface and leave it still until the LED on the 4-in-1 control unit

is solid (not blinking).

CAUTION: Always disconnect the Li-Po battery from the aircraft when not ﬂ ying to avoid over-discharging the

battery. Batteries discharged to a voltage lower than the lowest approved voltage may become damaged,

resulting in loss of performance and potential ﬁ re when batteries are charged.

Installing the Flight Battery