User Manual

11
EN
Takeo
When you are prepared to fl y, move both sticks into the bottom inside corners, then back to center. Increase the throttle
until the model is approximately 2 ft. (600mm) off the ground and check the trim so the model fl ies as desired. Once the
trim is adjusted, begin fl ying the model.
Typical fl ight times for the included battery range from 5 to 7 minutes.
Low Voltage Cuto (LVC)
LVC decreases the power to the motors when the battery voltage gets low. When the motor power decreases and the
LEDs blink, land the aircraft immediately and recharge the fl ight battery.
LVC does not prevent the battery from over-discharge during storage.
NOTICE: Repeated fl ying to LVC will damage the battery.
Landing
To land, slowly decrease the throttle while in a low-level hover. After landing, disconnect and remove the battery from
the aircraft after use to prevent trickle discharge. Fully charge your battery before storing it. During storage, make sure
the battery charge does not fall below 3V per cell.
Flying the 200 QX
Post-Flight Inspection and Maintenance Checklist
√
Cleaning
Make sure the battery is not connected before cleaning. Remove dust and debris with a soft brush
or a dry, lint-free cloth.
Motors Replace the motor when the model will not fl y steady or veers off when doing a climb out.
Wiring Make sure the wiring does not block moving parts. Replace damaged wiring and loose connectors.
Fasteners
Make sure there are no loose screws, other fasteners or connectors. Do not over-tighten metal
screws in plastic parts. Tighten screws so the parts are mated together, then turn the screw only
1/8th of a turn more.
Propellers
Make sure there is no damage to the propellers or other parts that move at high speed. Damage to
these parts includes cracks, burrs, chips or scratches. Replace damaged parts before fl ying.
Removing the Propellers
Optional Camera Mount
Remove the propeller nuts using the included propeller
nut wrench according to the illustration. Install them in the
opposite direction. Turn the silver prop nuts clockwise to
tighten. Turn the gold prop nuts counterclockwise to tighten.
A Camera mounting points
B Camera / Software update port
A
B
A
Silver Gold
SilverGold
Removing the propeller nuts