Instruction manual

11
EN
Installing the Flight Battery
1.Lowerthethrottle.
2.Poweronthetransmitter.
3.Centerthethrottletrim.
4.TurnthrottleholdonandmovetheightmodeswitchtoselectNormalmode.
5.Installtheightbatteryinthebatteryholder.ConnectthebatterycabletotheESC.
CAUTION:AlwayskeepthepowerleadpositionedAWAYfromtheelevatorservo.Failuretodoso
couldcausetheleadtogetcaught,resultinginacrashcausingpropertydamageandinjury.
6.Donotmovethehelicopteruntiltheybarlesscontrolunitinitializes.
7.TheLEDontheybarlesscontrolunitturnssolidbluewhenthehelicopterisinitialized.
8.OncetheESCbeepssignalingtheESCisinitialized,thehelicopterisreadyforight.
CAUTION: LowvoltagecutoffdoesnotprotecttheLi-Pobatteryduringstorage.Ifyouallowthe
Li-Pobatteryvoltagetofallbelow3Vpercell,youwilldamagethebattery.Thebatterywillno
longeracceptachargeandyouwillneedtoreplacethebattery.Thewarrantydoesnotapplytobatteries
damagedfromover-discharge.