Instruction manual

10
EN
Transmitter and Receiver Binding
BindingistheprocessofprogrammingthereceiverofthecontrolunittorecognizetheGUID(GloballyUnique
Identier)codeofasinglespecictransmitter.YouneedtobindyourchosenSpektrum
™
DSM
®
transmitterto
theybarlessunitbeforeyingthehelicopter.
General Binding Procedure
1.Disconnecttheightbatteryfromthehelicopter.
2.PoweroffthetransmitterandmakesuretheightmodeswitchisintheNormalposition.Movethe
throttletothelow/offposition.
3.Connecttheightbatterytotheybarlesscontrolunit.TheLEDontheybarlessunitashesafter5
seconds.
4.Putthetransmitterintobindmodewhilepoweringonthetransmitter.
5.Releasethebindbuttonafter2–3seconds.ThehelicopterisboundwhentheblueLEDontheybarless
unitissolid.
6.Disconnecttheightbatteryandpowerthetransmitteroff.

Ifyouencounterproblems,obeybindinginstructionsandrefertothetroubleshootingguideforother
instructions.Ifneeded,contacttheappropriateHorizonProductSupportofce.
CAUTION:FutabatransmittersequippedwithSpektrummodulesrequireyoutoreversethe
throttlechannel.