User Manual

14
EN
Once you have entered Gain Adjustment Mode, move the
cyclic stick right and left to select the gain parameter to
adjust. Moving the stick right will select the next parameter.
Moving the stick left will select the previous parameter.
The selected gain parameter is indicated on the Flight Log
screen above and by the lean of the swashplate on the roll
axis as shown in the table at the right.
Parameter #
Display
location
Swash Position Page #
1 A 100% to the Left 1
2 B 70% to the Left 1
3 L 40% to the Left 1
4 R 10% to the Left 1
5 A 10% to the Right 2
6 B 40% to the Right 2
7 L 70% to the Right 2
8 R 100% to the Right 2
Entering Gain Adjustment Mode
1. Lower the throttle stick to the lowest position.
2. Power ON the transmitter.
3. Install the fl ight battery on the helicopter frame,
securing it with the hook and loop strap.
4. Connect the battery connector to the ESC.
5. Place the helicopter on a fl at surface and leave it still
until the orange receiver LED glows solid, indicating
initialization is complete.
6. Move and hold
both transmitter
sticks to the bot-
tom right corner
as shown.
7. Press and hold the bind/panic switch until the swash
servos move.
8. Release the sticks and the bind/panic switch. The
model is now in Gain Adjustment Mode.
9. Proceed to Adjusting the Gain Values to make any
desired changes.
Adjusting the Gain Values
If you are using a Spektrum
™
telemetry-enabled transmit-
ter, the gain adjustments can be viewed on the Flight Log
screen. Refer to your transmitter instructions to locate this
screen. The gain parameter currently selected will fl ash
on the transmitter screen. If you are not using a Spektrum
telemetry-enabled transmitter, the parameter and gain
values are indicated by the position of the swashplate on
the helicopter.
P age number
1 = Cyclic gains
2 = Tail rotor gains
Gain parameter
selected
Gain value
display location
Flight Log Screen
The current gain value for the selected parameter is
indicated on the Flight Log screen and by the angle of the
swashplate (forward or backward) as shown in the table
at the right.
Move the cyclic stick forward or backward to adjust the
gain value. Moving the stick forward will increase the gain
value. Moving the stick backward will decrease the gain
value.
It is always best to adjust one gain at a time. Make small
adjustments (5% or less) and test fl y the model to evaluate
the adjustments that were made.
If you would like to reset the current gain value to the
default value of 100%, move and hold the rudder stick full
right for 1 second. The swash will level on the pitch axis,
indicating a 100% gain setting.
Saving the Gain Adjustments
1. Lower the throttle stick to the lowest position and
release the sticks.
2. Press and hold switch I until the swash servos move.
3. Release switch I to save the gain adjustments.
4. Reconnect the main drive motor to the ESC. Your model
is now ready for fl ight.
Swash Position Gain Value
Full backward 0%
50% backward 50%
Level forward and backward 100%
50% forward 150%
Full forward 200%