Instructions / Assembly

Push the orange handle into the alloy bracket as shown

in image A. Tighten the wing nut then close the lever so

the handle feels rm in place.

Take item C (label should be in the good reading position)

slide it over the top of item A and under the large lever

device cam saddle. Push the item C all the way back so the

large lever bolt nests into the end of the slot in item C.

Tighten the nut on the large lever bolt with the lever in

the open position, regulate the tightness, then snap the

lever device over to lock the item C on to the alloy bracket

(item A).

* To allow vertical storage: Slide the handle trap over the

top of the stainless steel blade (item C) and under the

lever bolt. Snap the lever down to hold the handle trap

against the stainless steel blade (item C).

Your Blade Sweep Broom is now ready for use.

Place item A over the top of the central recess in item B

and insert the large lever bolt through the hole in both

items A & B. Reattach the nut on the large lever bolt on

the bristle side of item B. Leave the nut on the large lever

bolt slightly loose.

Alloy Bracket

Broom Head

Handle Trap

Stainless

Steel Blade

Remove the nut and large bolt located at the bottom of

the alloy bracket.

Patented Design

PAGE 1
Patented Design A 1 Push the orange handle into the alloy bracket as shown in image A. Tighten the wing nut then close the lever so the handle feels firm in place. 2 Place item A over the top of the central recess in item B and insert the large lever bolt through the hole in both items A & B. Reattach the nut on the large lever bolt on the bristle side of item B. Leave the nut on the large lever bolt slightly loose. 3 Remove the nut and large bolt located at the bottom of the alloy bracket.