Technical data

RackSwitch G8124 Command Reference
46
 Chapter 2: Information Commands BMD00076, January 2009
Link Aggregation Control Protocol Information
Use these commands to display LACP status information about each port on the switch.
Link Aggregation Control Protocol
The following command displays LACP information:
show lacp information
Command mode: All
LACP dump includes the following information for each port on the switch:
 lacp
Displays the port’s LACP mode (active, passive, or off)
 adminkey
Displays the value of the port’s adminkey.
 operkey
Shows the value of the port’s operational key.
 selected
Indicates whether the port has been selected to be part of a Link Aggregation Group.
Table 2-15 LACP Information Commands
Command Syntax and Usage
show lacp aggregator {<port alias or number>}
Displays detailed information about the LACP aggregator used by the selected port.
Command mode: All
show lacp
Displays the configured global LACP settings.
Command mode: All
show lacp information
Displays a summary of LACP information. To view an example of the command output, see
page 46.
Command mode: All
port lacp adminKey operKey selected prio attached trunk status
aggr
------------------------------------------------------------------------------------
1 active 150 150 n 32768 -- -- Down
2 active 150 150 n 32768 -- -- Down
3 active 250 250 n 32768 -- -- Down
4 active 250 250 n 32768 -- -- Down
...