Technical data

RackSwitch G8124 Command Reference
38
 Chapter 2: Information Commands BMD00076, January 2009
General System Information
The following command displays system information:
show sys-info
Command mode: All
NOTE – The display of temperature will come up only if the temperature of any of the sensors
exceeds the temperature threshold. There will be a warning from the software if any of the sen-
sors exceeds this temperature threshold. The switch will shut down if the power supply over-
heats.
Blade Network Technologies Rack Switch G8124
System Information at
Thu Feb 02 21:04:11 2009
Switch has been up for 4 days, 15 hours, 36 minutes and 13 seconds
Last boot:(power cycle)
MAC Address: 00:17:ef:61:83:00
Management Port MAC Address: 00:22:00:7d:56:fe
Management Port IP Address: 127.16.2.54
Software Version 1.0.1, Boot Version 1.0.0.4, active config block
PCBA Part Number: ************
FAB Number: ************
Serial Number: ************
Manufacturing Date: ****
Hardware Revision: 255
Board Revision: ************
PLD Firmware version: ************
Fans are in Forward AirFlow, Warning at 85C and Failure at 100C
Temperature Sensor 1: 34.0 C
Temperature Sensor 2: 37.0 C
Temperature Sensor 3: --.-
Speed of Fan 1: 0 RPM
Speed of Fan 2: 0 RPM
Speed of Fan 3: 0 RPM
Speed of Fan 4: 4224 RPM
State of Power Supply 1: On
State of Power Supply 2: Off