Technical data

RackSwitch G8124 Command Reference
182
 Chapter 4: Configuration Commands BMD00076, January 2009
Failure Detection Pair Configuration
Use these commands to configure a Failure Detection Pair, which consists of one Link to Mon-
itor (LtM) and one Link to Disable (LtD). When the switch detects a failure on the LtM, it
automatically disables the ports in the LtD.
The following table describes the Failure Detection Pair (FDP) configuration commands.
Link to Monitor Configuration
The following table describes the Link to Monitor (LtM) commands.
Table 4-64 FDP Commands
Command Syntax and Usage
ufd fdp enable
Enables the Failure Detection Pair (FDP).
Command mode: Global configuration
no ufd fdp enable
Disables the Failure Detection Pair (FDP).
Command mode: Global configuration
show ufd fdp
Displays the current Uplink Failure Detection configuration parameters.
Command mode: Global configuration
Table 4-65 UFD LtM Commands
Command Syntax and Usage
[no] ufd fdp ltm port <1-24>
Adds a port to the LtM.
Command mode: Global configuration
[no] ufd fdp ltm portchannel <1-12>
Adds a static trunk group to the LtM.
Command mode: Global configuration
[no] ufd fdp ltm adminkey <13-65535>
Adds a LACP admin key to the LtM. Trunks formed with this admin key will be included in the
LtM.
Command mode: Global configuration