Technical data

RackSwitch G8124 Command Reference
166
 Chapter 4: Configuration Commands BMD00076, January 2009
Media Access Control Extended ACL Configuration
The Media Access Control (MAC) ACL configuration command creates Layer 2 MAC ACLs
and enters MAC Extended ACL configuration mode. Use the no form of the command to
delete the MAC ACL. ACLs on the system perform both access control and Layer 2 field clas-
sification. To define Layer 2 access lists, you must be in the MAC Extended ACL mode. This
command specifies the packets to be forwarded, based on the MAC address and the associated
parameters. The command allows non-IP traffic to be forwarded if the conditions are matched.
Table 4-53 MAC Extended ACL Commands
Command Syntax and Usage
permit
{any|host <source MAC address>}
{any|host <dest. MAC address>}
[user-priority <0-7>] [vlan <1-4094>]
Permits Layer 2 traffic that matches the specified criteria.
Command mode: MAC Extended ACL
deny
{any|host <source MAC address>}
{any|host <dest. MAC address>}
[user-priority <0-7>] [vlan <1-4094>]
Denies Layer 2 traffic that matches the specified criteria.
Command mode: MAC Extended ACL
permit
{any|host <source MAC address>}
{any|host <dest. MAC address>}
arp
[user-priority <0-7>] [vlan <1-4094>]
Permits Layer 2 traffic that matches the specified protocol type and associated parameters.
Command mode: MAC Extended ACL
deny
{any|host <source MAC address>}
{any|host <dest. MAC address>}
arp
[user-priority <0-7>] [vlan <1-4094>]
Permits Layer 2 traffic that matches the specified protocol type and associated parameters.
Command mode: MAC Extended ACL