Technical data

RackSwitch G8124 Command Reference
Chapter 4: Configuration Commands
 161BMD00076, January 2009
IGMP Static Multicast Router Configuration
Table 4-48 describes the commands used to configure a static multicast router.
Table 4-48 IGMP Static Multicast Router Configuration Commands
Command Syntax and Usage
ip igmp mrouter {<port alias or number>|<trunk group number>}
{<VLAN number (1-4094)>} <version (1-3)>
Selects a port/VLAN combination on which the static multicast router is connected, and configures
the IGMP version (1, 2, or 3) of the multicast router.
Note: To add a trunk group (portchannel), enter the trunk group number as follows: po1-po36
Command mode: Global configuration
no ip igmp mrouter {<port alias or number>|<trunk group number>}
{<VLAN number (1-4094)>} <version (1-3)>
Removes a static multicast router from the selected port/VLAN combination.
Command mode: Global configuration
clear ip igmp mrouter
Clears all dynamic multicast routers learned the switch.
Command mode: Global configuration
show ip igmp mrouter
Displays the current IGMP Static Multicast Router parameters.
Command mode: All except User EXEC