Technical data

RackSwitch G8124 Command Reference
160
 Chapter 4: Configuration Commands BMD00076, January 2009
IGMPv3 Configuration
Table 4-47 describes the commands used to configure IGMP version 3.
Table 4-47 IGMP Version 3 Configuration Commands
Command Syntax and Usage
ip igmp snoop igmpv3 sources {<1-64>}
Configures the maximum number of IGMP multicast sources to snoop from within the group
record. Use this command to limit the number of IGMP sources, to provide more refined control.
Command mode: Global configuration
[no] ip igmp snoop igmpv3 v1v2
Enables snooping on IGMP version 1 and version 2 reports. When disabled, the switch drops
IGMPv1 and IGMPv2 reports. The default value is enabled.
Command mode: Global configuration
[no] ip igmp snoop igmpv3 exclude
Enables snooping on IGMPv3 Exclude Reports. When disabled, the switch ignores Exclude
Reports. The default value is enabled.
Command mode: Global configuration
[no] ip igmp snoop igmpv3 enable
Enables or disables IGMP version 3. The default value is disabled.
Command mode: Global configuration
show ip igmp snoop
Displays the current IGMP snooping parameters.
Command mode: All