Technical data

RackSwitch G8124 Command Reference
158
 Chapter 4: Configuration Commands BMD00076, January 2009
Default Gateway Configuration
NOTE – The switch has one default gateway.
This option is disabled by default.
IGMP Configuration
Table 4-45 describes the commands used to configure basic IGMP parameters.
Table 4-44 Default Gateway Commands
Command Syntax and Usage
ip gateway address {<IP address>}
Configures the IP address of the default IP gateway using dotted decimal notation.
Command mode: Interface IP
[no] ip gateway enable
Enables the gateway. The default setting is disabled.
Command mode: Interface IP
Table 4-45 IGMP Configuration Commands
Command Syntax and Usage
[no] ip igmp fastleave <1-4094>
Enables or disables FastLeave processing on the selected VLAN. FastLeave allows the switch to
immediately remove a port from the IGMP port list, if the host sends a Leave message, and the
proper conditions are met. The default setting is disabled.
Command mode: Global configuration
[no] ip igmp flood
Configures the switch to flood unregistered IP multicast reports to all ports.
The default setting is enabled.
Command mode: Global configuration
ip igmp timeout <130-1225>
Sets the report timeout interval, in seconds. The default value is 260.
Command mode: Global configuration