Technical data

RackSwitch G8124 Command Reference
Chapter 4: Configuration Commands
 157BMD00076, January 2009
IP Interface Configuration
You can configure the management IP interface on the switch. The IP interface allows in-band
management of the switch. Interface 1 is enabled by default.
Table 4-43 IP Interface Configuration Commands
Command Syntax and Usage
interface ip 1
Enter IP interface mode.
Command mode: Global configuration
ip address {<IP address>}
Configures the IP address of the switch interface, using dotted decimal notation.
Command mode: Interface IP
ip netmask {<IP netmask>}
Configures the IP subnet address mask for the interface, using dotted decimal notation.
Command mode: Interface IP
ipvlan <1-4094>
Configures the VLAN number for this interface. Each VLAN can contain only one IP interface.
Command mode: Interface IP
[no] dhcp enable
Enables or disables the DHCP client. The default setting is enabled on interface 1.
Command mode: Interface IP
[no] enable
Enables or disables the IP interface. The default setting is enabled on interface 1.
Command mode: Interface IP
show interface ip 1
Displays the current interface settings.
Command mode: All