Technical data

RackSwitch G8124 Command Reference
Chapter 4: Configuration Commands
 135BMD00076, January 2009
Port FDB Configuration
This section describes the port Forwarding Database (FDB) configuration commands.
Temporarily Disabling a Port
To temporarily disable a port without changing its stored configuration attributes, enter the
following command at any prompt:
Because this configuration sets a temporary state for the port, the port state will revert to its
original configuration when the switch is reset. See the “Operations Commands” on page 191
for other operations-level commands.
Table 4-24 Port FDB Configuration
Command Syntax and Usage
[no] mac-address-table flooding
Enables flooding on this interface.
Command mode: Interface port
[no] mac-address-table learning
Enables FDB learning on this interface.
Command mode: Interface Port
[no] mac-address-table mac-notification
Enables MAC Address Notification on the port. With MAC Address Notification enabled,
the switch generates a syslog message when a MAC address is added or removed from the MAC
address table.
Command mode: Interface Port
G8124# interface port <port alias or number> shutdown