Technical data

RackSwitch G8124 Command Reference
130
 Chapter 4: Configuration Commands BMD00076, January 2009
User Access Control Configuration
The following table describes user-access control commands.
NOTE – User passwords can be a maximum of 128 characters.
Table 4-20 User Access Control Configuration Commands
Command Syntax and Usage
access user <1-10>
Configures the User ID.
Command mode: Global configuration
access user eject [console-user]
Ejects the current console user from the switch.
Command mode: Global configuration
access user eject <user name> [<IP address>] [<Telnet/SSH port number>]
Ejects the specified user(s) from the switch.
Command mode: Global configuration
access user user-password <1-128 characters>
Sets the user (user) password. The user has no direct responsibility for switch management. The
user can view switch status information and statistics, but cannot make any configuration changes.
Command mode: Global configuration
access user operator-password <1-128 characters>
Sets the operator (oper) password. The operator has no direct responsibility for switch manage-
ment. The operator can view switch status information and statistics, but cannot make any configura-
tion changes.
Command mode: Global configuration
access user administrator-password <1-128 characters>
Sets the administrator (admin) password. The super user administrator has complete access to all
information and configuration commands on the switch, including the ability to change both the
user and administrator passwords.
Access includes “oper” functions.
Command mode: Global configuration
show access user
Displays the current user status.
Command mode: All except User EXEC