Installation guide

RackSwitch G8124 Installation Guide
30
 Chapter 2: Installing the RackSwitch G8124 BPP-00018-01, December 2009
Perform the following steps to mount the RackSwitch G8124 into a standard 4-post rack.
1. Use the M4 screws to attach a horizontal rail to each side of the switch.
Torque the screws to approximately 10 inch-pounds (1.1 Nm).
Figure 10 Attaching the Horizontal Rail
2. M6 screws, washers, and clip nuts are used to connect the horizontal rail to the front posts in the
rack. Torque the screws to approximately 70 inch-pounds (8.0 Nm).
Figure 11 Rack-Mounting the Switch Unit