Installation guide
RackSwitch G8124 Installation Guide
28
Chapter 2: Installing the RackSwitch G8124 BPP-00018-01, December 2009
2. M6 screws, washers, and clip nuts are used to attach the alignment plate.
Torque the screws to approximately 30 inch-pounds (3.5 Nm).
Figure 8 Attaching the Alignment Plate
3. M6 screws, washers, and clip nuts are used to mount the switch unit into the rack.
Torque the screws to approximately 30 inch-pounds (3.5 Nm).
Figure 9 Rack-Mounting the Switch Unit