Installation guide

RackSwitch G8124 Installation Guide
26
 Chapter 2: Installing the RackSwitch G8124 BPP-00018-01, December 2009
Installing the RackSwitch G8124 in an
iDataPlex Rack
This section provides general information about installing the RackSwitch G8124 in an
IBM iDataPlex rack. The iDataPlex mounting kit allows the switch to be mounted either
vertically or horizontally. For information about mounting the G8124 in other rack types,
refer to the following sections:
 “Installing the RackSwitch G8124 in a Standard Equipment Rack” on page 23
 “Installing the RackSwitch G8124 in a 4-post Rack” on page 29
The mounting kit is ordered separately. The following table lists the parts included in
the iDataPlex mounting kit.
Table 14 BN-MNT-DPX-RLS iDataPlex Rack Mount Kit
Item number Part number Description Quantity
1 BMM-00098-00 Rear brackets 2
2 BMM-00056-00 Front brackets 2
3 BMM-00066-00 Alignment plate 2
4 BMC-00056-00 M6 screws 8
4 BMC-00015-01 M6 locking washers 8
4 BMC-00069-00 M6 clip nuts 8
5 BMC-00049-00 M4 screws 16