Specifications

280 Implementing IBM System Networking 10Gb Ethernet Switches
4. Verify the VRRP operation
Run the commands listed in this step to verify the VRRP operation on the switch.
Run show ip vrrp to display the current VRRP parameters (Example 6-38).
Example 6-38 Verify the VRRP current parameters
AGG-1#show ip vrrp
Current VRRP settings: ON
Current VRRP hold off time: 0
Current VRRP Tracking settings:
vrs 2, ifs 2, ports 50
Current VRRP Virtual Router Group:
vrid 1, if 1, prio 100, adver 1, disabled
preem enabled, fast-advertisement disabled
track nothing
Current VRRP virtual router settings:
3: vrid 30, 10.0.30.1, if 30, prio 105, adver 2, enabled
preem enabled, predelay 5, fast-advertisement disabled
track ports
AGG-1#
AGG-2#show ip vrrp
Current VRRP settings: ON
Current VRRP hold off time: 0
Current VRRP Tracking settings:
vrs 2, ifs 2, ports 50
Current VRRP Virtual Router Group:
vrid 1, if 1, prio 100, adver 1, disabled
preem enabled, fast-advertisement disabled
track nothing
Current VRRP virtual router settings:
3: vrid 30, 10.0.30.1, if 30, prio 100, adver 2, enabled
preem enabled, predelay 5, fast-advertisement disabled
track ports
AGG-2#
Run show ip vrrp virtual-router <1-15> to display the current VRRP parameters of
the selected virtual router (Example 6-39).
Example 6-39 Verify the selected virtual router current parameters
AGG-1#show ip vrrp virtual-router 3
Current VRRP virtual router 3:
vrid 30, 10.0.30.1, if 30, prio 105, adver 2, enabled
preem enabled, predelay 5, fast-advertisement disabled
track ports
AGG-1#
AGG-2#show ip vrrp virtual-router 3