Specifications

264 Implementing IBM System Networking 10Gb Ethernet Switches
2:7 71 y Internal d e e 1 2:7 1 4095
2:8 72 y Internal d e e 1 2:8 1 4095
2:9 73 y Internal d e e 1 2:9 1 4095
2:10 74 y Internal d e e 1 2:10 1 4095
2:11 75 y Internal d e e 1 2:11 1 4095
2:12 76 y Internal d e e 1 2:12 1 4095
2:13 77 y Internal d e e 1 2:13 1 4095
2:14 78 y Internal d e e 30 SRV-3 30
2:15 79 y RemoteMgmt d e e 4095* 2:15 4095
2:16 80 y RemoteMgmt d e e 4095* 2:16 4095
2:17 81 n External d e e 30 AGG1-ACC3 30
2:18 82 n External d e e 30 AGG2-ACC3 30
2:19 83 n External d e e 1 2:19 1
2:20 84 n External d e e 1 2:20 1
2:21 85 n External d e e 1 2:21 1
2:22 86 n External d e e 1 2:22 1
2:23 87 n External d e e 1 2:23 1
2:24 88 n External d e e 1 2:24 1
2:25 89 n Stacking d e e 1 2:25 Stacking
2:26 90 n Stacking d e e 1 2:26 Stacking
2:27 91 n External d e e 1 2:27 1
* = PVID is tagged.
ACC-3#
Private VLANs
This feature is not in the scope of the reference architecture implementation. However, a
summary of commands used for configuration and verification is presented in this section.
For more information about private VLANs concept, see 2.1, “Virtual Local Area Networks” on
page 52.
Use the following commands to configure Private VLANs:
򐂰 Run private-vlan type primary at the VLAN level to configure the VLAN type as a
Primary VLAN. A Private VLAN must have only one primary VLAN. The primary VLAN
carries unidirectional traffic to ports on the isolated VLAN or to community VLAN.
򐂰 Run private-vlan type community at the VLAN level to configure the VLAN type as a
community VLAN. Community VLANs carry upstream traffic from host ports. A Private
VLAN may have multiple community VLANs.
򐂰 Run private-vlan type isolated at the VLAN level to configure the VLAN type as an
isolated VLAN. The isolated VLAN carries unidirectional traffic from host ports. A Private
VLAN may have only one isolated VLAN.
򐂰 Run no private-vlan type to clear the private-VLAN type.
򐂰 Run [no] private-vlan map [<2-4094>] to configure Private VLAN mapping between a
secondary VLAN and a primary VLAN. Enter the primary VLAN ID. Secondary VLANs
have the type defined as isolated or community. Use the no option to remove the mapping
between the secondary VLAN and the primary VLAN.
򐂰 Run [no] private-vlan enable at the VLAN level to enable or disable the Private VLAN.
򐂰 Run show private-vlan [<2-4094>] to show the current parameters for the selected
Private VLANs.