Specifications

214 Implementing IBM System Networking 10Gb Ethernet Switches
ACC-2(config-router-ospf3)#^Z
ACC-2#
6. Verify OSPF.
Run the following commands to verify OSPF operation:
– show ipv6 ospf
– show ipv6 ospf neighbor
– show ipv6 ospf database
– show ipv6 ospf routes
– show ipv6 route
See the following examples for the ACC-1 switch for these commands’ output.
Show the current OSPFv3 configuration settings by running show ipv6 ospf
(Example 5-61).
Example 5-61 Show ipv6 ospf command output
ACC-1#show ipv6 ospf
Current OSPFv3 settings: ON
Router ID: 2.2.2.1
lsdb limit none,exit overflow interval 0, ref bw 100000
spf delay 5, spf holdtime 10, abr type standard
nssaAsbrDfRtTrans disabled
Current OSPFv3 area settings:
0: 0.0.0.0, type transit, transl role candidate, default metric 1
type 1, stb 40, nosumm disabled, enabled
Current OSPFv3 interface settings:
111: fc11:0:0:0:0:0:0:1/64, area index 0, instance 0,
enabled
prio 1, cost 1, hello 10, dead 40, trans delay 1, passive disabled, retra 5
Current IPSec AH protocol: disabled
AH algorithm: none, key , spi 0
Current IPSec ESP protocol: disabled
ESP authentification algorithm none, authentification key
Encryption algorithm null, encryption key , spi 0
112: fc12:0:0:0:0:0:0:1/64, area index 0, instance 0,
enabled
prio 1, cost 1, hello 10, dead 40, trans delay 1, passive disabled, retra 5
Current IPSec AH protocol: disabled
AH algorithm: none, key , spi 0
Current IPSec ESP protocol: disabled
ESP authentification algorithm none, authentification key
Encryption algorithm null, encryption key , spi 0
Current OSPFv3 Route Redistribution settings
Connected Export all with route metric 2, type 1, tag unset
ACC-1#