Specifications

198 Implementing IBM System Networking 10Gb Ethernet Switches
IPv4 and IPv6 addresses are configured by using the input information from Chapter 3,
“Reference architectures” on page 107. The static IPv4 and IPv6 configuration on the
interface is shown in Figure 5-4.
Figure 5-4 Windows IPv4 and IPv6 static addresses configuration
If the Router Advertisements protocol is enabled on the switch (see step 2 on
page 195), then the IPv6 interface on the host auto-configures itself using the
advertised prefix, as shown in Figure 5-5.
Figure 5-5 Windows IPv6 auto-configuration